Pre -hot stainless steel collector of 7 outputs for hydraulic radiant floor - Waternor - Hidroradi

Consisting of: - 1 Stainless Steel Return Collector with Cutting Valves For Electrothermal Actuators - 1 Greenery Stainless Steel Control Collector - 2 Complete Fixing Sets - 2 Thermometer Manual Cutting Valves - 2 End of Course Accessories with Automatic and discharge Measurement: 1 "Maximum working pressure: 6 bar Maximum test pressure: 10 bar Maximum temperature: 70 ° C compliance with: ISO 228 (equivalent to DIN EN ISO 228 and BS EN ISO 228) Outputs: Models 2 A 13 with measurement "Ready to Use" Wateror are made in full stainless steel. Traditional brass collectors resort to a 3 mm thick wall, a wall that in the case of stainless steel is reduced to a thickness of 1.5 MM. Stainless steel collectors are always lighter and the material itself has superior resistance. Stainless steel is a raw material with a different brass's versatility, this allowed the development of collectors with parallel sections, evolution in the face of traditional traditional brass collectors of alternate parallel sections. This innovation allowed an increase in the rate of caudal rate achieved, from 3.5 m³/h, in traditional collectors, up to 5 m³/h with parallel section collectors continuing stainless steel integral construction. This innovation has gained strength in the market by introducing new heating systems, namely invisible climate control systems, or hydraulic radiant floor. These are facilities with larger working tails than any other heating system which makes stainless steel collectors the best option for this type of solution. ROBUSTE ADVANTAGES - Stainless steel is 21% stronger than brass. Peso Peso - The "Ready to Use" Wateror Collectors are 50% lighter than the traditional brass -built traditional collectors. Corrosion Resistance - Stainless steel has a high corrosion resistance. More caudal - The "Ready to Use" Wateror collectors get a 20% higher flow rate than traditional brass collectors due to their higher section. Low and high temperature - Unlike collectors manufactured in composite materials, the "Ready to" Wateror collectors can withstand temperature fluctuations. ABSENCE OF JOINTS - Collectors made of composite materials are modular and require fixing systems to reinforce the connections, where each fixing joint can represent a potential rupture point,On the contrary, the "Ready to Use" Wateror collectors are manufactured in a single piece with several exits according to the project. Visual Quality and Aesthetic Performance - Stainless Steel is a more pleasant material in quanfo compared to polymeric materials or brass. It is also universally recognized as a premium material.